Preparation and Cytotoxicity of Poly(Methyl Methacrylate) Nanoparticles for Drug Encapsulation

Summary: This work aimed to produce poly(methyl methacrylate) nanoparticles for use in drug encapsulation. The polymer nanoparticles were produced using miniemulsion polymerization technique. Monomer miniemulsion showed moderate stability and polymer average particle size was about 90 nm. PMMA nanoparticles were tested for toxicity in human leukemic cell strain K562 and they did not show any adverse effect on cell viability. Therefore, poly(methyl methacrylate) nanoparticles are suitable to encapsulate antitumor agents.     

Fast screening for antioxidant properties of flavonoids from Pterogyne nitens using electrochemical methods

A fast, low-cost, convenient, and especially sensitive voltammetric screening approach for the study of the antioxidant properties of isoquercitrin and pedalitin from Pterogyne nitens is suggested in this work. These flavonoids were investigated for their redox properties using cyclic voltammetry in nonaqueous media using N,N-dimethylformamide and tetrabutylammonium tetrafluorborate as the supporting electrolyte, a glassy carbon working electrode, A6(see symbol in text)AgCI reference electrode, and Pt bare wire counter electrode. The comparative analysis of the activity of rutin has also been carried out. Moreover, combining HPLC with an electrochemical detector allowed qualitative and quantitative detection of micromolecules (e.g., isoquercitrin and pedalitin) that showed antioxidant activities. These results were then correlated to the inhibition of beta-carotene bleaching determined by TLC autographic assay and to structural features of the flavonoids.     

Linear parameter varying control design for rotating systems supported by journal bearings

Linear parameter varying (LPV) control is a model-based control technique that takes into account time-varying parameters of the plant. In the case of rotating systems supported by lubricated bearings, the dynamic characteristics of the bearings change in time as a function of the rotating speed. Hence, LPV control can tackle the problem of run-up and run-down operational conditions when dynamic characteristics of the rotating system change significantly in time due to the bearings and high vibration levels occur. In this work, the LPV control design for a flexible shaft supported by plain journal bearings is presented. The model used in the LPV control design is updated from unbalance response experimental results and dynamic coefficients for the entire range of rotating speeds are obtained by numerical optimization. Experimental implementation of the designed LPV control resulted in strong reduction of vibration amplitudes when crossing the critical speed, without affecting system behavior in sub- or super-critical speeds.     

Peroxidase activity of new mixed‐valence cobalt complexes with ligands derived from pyridoxal

New mixed‐valence cobalt complexes with ligands derived from pyridoxal were synthesized and characterized, and their application as mimetics of the peroxidase enzyme was investigated. Single‐crystal X‐ray diffraction was used to analyze all complex structures in the solid state and their electrochemical behavior was investigated. A reactivity pattern was observed in the complex synthesis regarding the cobalt compounds from which analogous zwitterionic derivatives were obtained. The importance of these compounds lies in understanding their behavior in an oxidizing environment and evaluating whether they can activate hydrogen peroxide to oxidize phenolic compounds. In nature, enzymes called peroxidases, which efficiently oxidize phenolic compounds, trigger many reactions involving the activation of hydrogen peroxide to oxidize organic substrates. However, these enzymes present several disadvantages, including denaturation and elevated costs. Therefore, these limitations can be overcome by expanding research into the study of synthetic catalysts for the oxidation of phenolic compounds using hydrogen peroxide, which is a highly relevant field of bioinorganic chemistry.     

A rapid technique to determine the internal area function of finite-length ducts using maximum length sequence analysis

This paper describes a rapid technique for reconstruction of the internal area function of a duct using blockage-induced eigenvalue shifts determined from eigenfrequencies measured under two sets of duct termination boundary conditions. A single broad band maximum length sequence (MLS) measurement of short duration is utilized to obtain the transfer function of the duct, which in turn can be utilized to determine its eigenvalue shifts and subsequently its internal area function using an inverse perturbation technique. The reconstruction results display the same order of accuracy as those obtained previously using swept sine measurements of extended duration. An expression for the determination of the area function is presented utilizing resonant frequency information alone, thus rendering duct length determination unnecessary. A computational routine further simplifies the process such that the accuracy of the technique could be ascertained for a range of configurations including longer ducts and ducts that initially have nonuniform internal cross section over their length. Development of a relationship between obstacle length and wavelength of the lowest eigenfrequency required for successful reconstruction is also described. This is an important result for longer ducts where measurement of lower eigenfrequencies may present problems using standard measurement equipment.     

Displacement of adsorbed functionalized polystyrene-block-butadiene copolymers by small molecules

This work deals with the displacement of end-anchored copolymers by the addition of solvent displacer. The adsorption behavior of functionalized polystyrene-block-polybutadiene diblock copolymers from dilute solution in toluene using silicon wafers as solid substrates is investigated by means of null-ellipsometry. The desorption phenomena are observed by adding displacers of low molecular weight to the mixture. The displacers used are tetrahydrofuran (THF) and acetone. The critical composition of the binary solvent mixture at which the desorption is complete, is determined experimentally.     

Modified Particle Detachment Model for Colloidal Transport in Porous Media

Particle detachment from the rock during suspension transport in porous media was widely observed in laboratory corefloods and for flows in natural reservoirs. A new mathematical model for detachment of particles is based on mechanical equilibrium of a particle positioned on the internal cake or matrix surface in the pore space. The torque balance of drag, electrostatic, lifting and gravity forces, acting on the particle from the matrix and the moving fluid, is considered. The torque balance determines maximum retention concentration during the particle capture. The particle torque equilibrium is determined by the dimensionless ratio between the drag and normal forces acting on the particle. The maximum retention function of the dimensionless ratio (dislodging number) closes system of governing equations for colloid transport with particle release. One-dimensional problem of coreflooding by suspension accounting for limited particle retention, controlled by the torque sum, allows for exact solution under the assumptions of constant filtration coefficient and porosity. The explicit formulae permit the calculation of the model parameters (maximum retention concentration, filtration and formation damage coefficients) from the history of the pressure drop across the core during suspension injection. The values for maximum retention concentration, as obtained from two coreflood tests, have been matched with those calculated by the torque balance on the micro scale.     

The first intramolecular Heck-Matsuda reaction and its application in the syntheses of benzofurans and indoles

In this Letter, we report, for the first time, the development of an efficient method for the intramolecular Heck reaction of arenediazonium salts in the synthesis of benzofuran and indole derivatives. In addition, this methodology allowed the synthesis of a series of dihydrobenzofuran acetic acid derivatives via a domino Heck-Matsuda coupling-carbonylation reaction.